A neutralizer of limescale and dirt on old natural stone (marble, shell rock, travertine, etc.), after processing the stone returns to its original purity.
 Technical description:
 READY TO APPLY
 • DOES NOT CHANGE SURFACE COLORS;
 • DOES NOT CONTAIN HYDROCALIC AND ORTHOPHOSPHORIC ACID;
 • DOES NOT CONTAIN SUBSTANCES PROMOTING THE DESTRUCTION OF MARBLE;
 • CLEANSES AND PROTECTS STONE SURFACE
 • FOR INTERIOR AND EXTERIOR USE
 Type of material: The composition is intended for quick and high-quality cleaning of the surface of products made of marble, granite and natural stone from all types of contamination.
 Ingredients: Water, surfactants, acidity regulator, preservative.
 Color: Colorless.
 Density: Approximately 1.0 g / cm3.
 Application: By brush, roller, sponge.
 Application: It is intended for cleaning the surface of products made of marble, granite, limestone and other natural stone, as well as removing lime and atmospheric contaminants from the surface of granite and other natural stones on facades, monuments, etc.
 Properties: Effectively cleans the surface of natural stone. Does not destroy marble. Removes both water-soluble and water-insoluble contaminants of carbonate, sulphate and lime types. The composition is ready to use, does not contain strong acids. Leaves no residue after drying. Effectively protects the treated surface from subsequent contamination.
 Substrate preparation: Dust the surface and clean it from dirt, fuel oil, grease.
 Application procedure: Moisten the surface to be treated with water using a spray gun. Apply the product to a damp surface at a temperature not lower than + 5 ° C using a roller, brush, or spray. To remove light dirt, the composition should be pre-diluted with water in a ratio of 1: 4. After application, wait 1-2 minutes and then clean with a brush, sponge, or cloth. After cleaning, rinse the surface with plenty of clean water. To clean heavily soiled surfaces, use undiluted cleaner and increase the waiting time to 3-5 minutes. When cleaning granite and other hard stones, use a wire mesh sponge. If the cleaning result is unsatisfactory, it is necessary to repeat the treatment. Before using the composition on decorative colored products, it is required to pre-process a small area in order to determine that there is no change in the color of the product.
 Cleaning of instruments: With water and soap, immediately after use.
 Storage: Store in a cool and dry place, protected from frost. Store opened packaging tightly sealed.
 Shelf life in tightly closed original packaging is 12 months.
 Packing: 0.5 l, 5 l.
 Consumption: Consumption of the composition depends on the degree of contamination and the absorbency of the surface and is 100-150 g / m2. The most accurate method of setting the flow rate is a test application.
 Processing temperature: Temperature not lower than + 5 ° C, relative air humidity not higher than 80%.
 Precautionary measures: Means fire and explosion-proof. Do not mix with other types of products. Avoid contact with eyes and skin during and after work. When applying, use personal protective equipment for respiratory organs (respirators), skin of hands (gloves) and eyes (goggles). Do not let the excess dry on the surface, rinse it off with water. In case of contact with eyes, rinse immediately with plenty of water and seek medical attention. If swallowed, seek medical attention immediately and show this container or label. Keep out of reach of children. Do not empty into drains, waterways or soil.
 Disposal: According to local regulations.